![]() ![]() Screw the boards into the roof logs, ensuring that they're countersunk for a flat finish.Fold back the rubber from the edge of the roof at the ends so that you can affix the first set of fascia boards.Run a knife along the back edge of the timbers and trim the excess rubber off.This allows rainwater to drip from the rubber rather than damaging the wood. Fold the rubber under the edge of the roof on each side of the building, and screwing in batons under the edge, approximately an inch in from the edge. ![]() Trim the rubber with a sharp knife at the edge of the capping, pulling it forward slightly so that when cut it retracts underneath the capping, leaving a tidy edge.Īffix batons before fixing your fascia boards in Image: Waltons Affix the capping to the shed ends, and then fix the corner caps in place with pins. ![]() Do this before you put the plastic capping on the ends of the shed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |